Cara Download Skema Rangkaian Indikator Ketinggian Air Update Terbaru

Sedikit Info Seputar Skema Rangkaian Indikator Ketinggian Air Terbaru 2017 - Hay gaes kali ini team Game Android Apk, kali ini akan membahas artikel dengan judul Skema Rangkaian Indikator Ketinggian Air, kami selaku Team Game Android Apk telah mempersiapkan artikel ini untuk sobat sobat yang menyukai Game Android Apk. semoga isi postingan tentang Artikel Home Circuits, Artikel Indikator ketinggian Air, yang saya posting kali ini dapat dipahami dengan mudah serta memberi manfa'at bagi kalian semua, walaupun tidak sempurna setidaknya artikel kami memberi sedikit informasi kepada kalian semua. ok langsung simak aja sob
Judul: Berbagi Info Seputar Skema Rangkaian Indikator Ketinggian Air Terbaru
link: Skema Rangkaian Indikator Ketinggian Air

Berbagi Skema Rangkaian Indikator Ketinggian Air Terbaru dan Terlengkap 2017

Skema Rangkaian Indikator Ketinggian Air

By means of a Relay, employed to drive a water pump, this circuit provides automatic level control of a water reservoir or well.

Skema Rangkaian Indikator Ketinggian Air

Note:

• The two steel rods must be supported by a small insulated (wooden or plastic) board.
• The circuit can be used also with non-metal tanks, provided a third steel rod having about the same height of the tank will be added and connected to the circuit's negative ground.

The shorter steel rod is the "water high" sensor, whereas the longer is the "water low" sensor. When the water level is below both sensors, IC1C output (pin #10) is low; if the water becomes in contact with the longer sensor the output remains low until the shorter sensor is reached. At this point IC1C output goes high, Q1 conducts, the Relay is energized and the pump starts operating.

Now, the water level begins to decrease and the shorter sensor will be no longer in contact with the water, but IC1C output will be hold high by the signal return to pin #5 of IC1B, so the pump will continue its operation. But when the water level falls below the longer sensor, IC1C output goes low and the pump will stop.

SW1 is optional and was added to provide reverse operation. Switching SW1 in order to connect R3 to pin #11 of IC1D, the pump will operate when the reservoir is nearly empty and will stop when the reservoir is full. In this case, the pump will be used to fill the reservoir and not to empty it as in the default operating mode.

List Component

• R1,R2: 15K 1/4W Resistors
• R3: 10K 1/4W Resistor
• R4: 1K 1/4W Resistor
• D1: LED
• D2: 1N4148 Diode
• IC1: 4001
• Q1: BC337 NPN Transistor
• SW1: witch
• RL1: Relay with SPDT 2A @ 230V switch, Coil Voltage 12V

Itulah sedikit Artikel Skema Rangkaian Indikator Ketinggian Air terbaru dari kami

Semoga artikel Skema Rangkaian Indikator Ketinggian Air yang saya posting kali ini, bisa memberi informasi untuk anda semua yang menyukai Game Android Apk. jangan lupa baca juga artikel-artikel lain dari kami.

Terima kasih Anda baru saja membaca Skema Rangkaian Indikator Ketinggian Air